Siemens SINUMERIK 840D Funktionsbeschreibung Seite 718

Wiederaufsetzen – Retrace Support (TE7)
5.4 Alarmtexte anlegen
bzw. in TF_UK.COM:
3/TE7/5-38
075600 0 0 "Channel %1 Retrace Support: invalid MD–configuration,
error no. %2"
075601 0 0 "Channel %1 block %2 invalid argument of CC_PREPRE()"
075604 0 0 "Channel %1 retracing not possible, error no. %2"
075605 0 0 "Channel %1 Retrace Support: internal error, error no. %2"
075606 0 0 "Channel %1 retraceable contour was shortened"
075607 0 0 "Channel %1 program continuation not possible"
075608 0 0 "Channel %1 NC memory is full, RAM type %2"
075609 0 0 " Channel %1 RESU axis, wrong axis config.,
axis type %2, block %3"
075610 0 0 " Channel %1 RESU, NC START not possible"
SINUMERIK 840D/840Di/810D Funktionsb. Sonderfunktionen (FB3) – Ausgabe 11.02
 Siemens AG 2002 All Rights Reserved
08.02
09.95
J