Drv.handwheelsrc - Kollmorgen AKD Series Benutzerhandbuch

AKD Benutzerhandbuch | 25.13.32 DRV.HANDWHEELSRC

25.13.32 DRV.HANDWHEELSRC

General Information
Type
Description
Units
Range
Default Value
Data Type
See Also
Start Version
Variants Supported
AKD BASIC
AKD SynqNet
AKD EtherNet/IP
Fieldbus Information
Fieldbus Index/Subindex Is 64 bit? Attributes Signed?
Modbus 1224
Description
This command sets the feedback which will be used as the handwheel source. If the selected Feedback
is incompatible with the selected emulated encoder mode, a warning will be displayed.
Feedback 3 is only supported on drives with model numbers similar to AKD-x-xxxxx-NBxx-xxxx and will
only work with Endat 2.2 multiturn encoder.
551 KOLLMORGEN | Mai 2013
NV Parameter
Selects the feedback for handwheel operation.
None
2-3
2
U8
N/A
M_01-05-08-000
Variant Supported
No 8 bit
√
N/A
N/A
No