Drv.faults - Kollmorgen AKD Series Benutzerhandbuch

AKD Benutzerhandbuch | 25.13.30 DRV.FAULTS

25.13.30 DRV.FAULTS

General Information
Type
Description Reads the active faults.
Units
Range
Default
Value
Data Type
See Also
Start Ver-
sion
Variants Supported
AKD BASIC
AKD SynqNet
AKD EtherNet/IP
Description
DRV.FAULTS returns a list of all currently active faults in the system, preceded by their fault number
which matches the number displayed on the drive display.
To clear the faults, either issue a DRV.CLRFAULTS or issue a DRV.DIS followed by DRV.EN.
If no active faults are in the system, then after executing DRV.CLRFAULTS the value read by
DRV.FAULTS is "No faults active".
Example
-->DRV.FAULTS
502: Bus under voltage.
-->
549 KOLLMORGEN | Mai 2013
R/O Parameter
N/A
N/A
N/A
N/A
DRV.CLRFAULTS (s: 520), DRV.FAULTHIST (s: 547), DRV.CLRFAU-
LTHIST (s: 519)
M_01-00-00-000
Variant Supported
√
√
N/A