Yamaha RD125C Servicehandbuch Seite 369

RD125(DX)
RD200(DX)
4) Connecting Rod Small End Deflection (P)
P
C <=>
D-HI— n
D
4JÜLU
A
U U
— F — | p — F — "
A •
2 mm (0.079 in)
-
5) Crank Pin Outside Diameter x Length 18 mm x 42.6 mm (0.71 x 1.677 in)
20 mm x 46 mm (0.79 x 1.81 in)
6) Crank Pin Type Hollowtype
7) Crank Bearing Type (Left) x Q'ty 6304C3 x 1 pc. 6205C3 x 1 pc.
Crank Bearing Type (Center) x Q'ty 6205 x 2 pcs.
Crank Bearing Type (Right) x Q'ty 6304C3x 1 p
C
. 6305C3 x 1 pc.
8) Crank Oil Seal Type (Left) x Q'ty SD-20-40-8 x 1 pc.
Crank Oil Seal Type (Center) x Q'ty Labyrinth seal x 1 pc.
Crank Oil Seal Type (Right) x Q'ty
9. CLUTCH
SW-28-40-8 x 1 p
C
. SW-32-48-8 x 1 pc.
1) Clutch Type Wet, multiple disc type
2) Clutch Operating Mechanism Inner push type screw push System
3) Primary Reduction Ratio and Method 74/19 3.894 gear 53/16 3.312 gear
4) Friction Plate—Thickness/Quantity
3.0 mm (0.12 in)/5 pcs.
4.0 mm (0.16 in)/5 pcs.
Friction Plate—Wear limit 2.7 mm (0.11 in) 3.7 mm (0.15 in)
5) Clutch Plate -Thickness/Quantity 1.6 mm (0.063 in)/5pcs. 1.6 mm (0.063 in)/4pcs.
Clutch Plate—Warp Limit 0.05 mm (0.002 in)
6) Clutch Spring — Free Length — Quantity
31.5 mm (1.24 in)/5 pcs. 34.0 mm (1.34 in)/5 pcs.
Clutch Spring—Minimum Length
30.5 mm (1.20 in) 33.0 mm (1.30 in)
7) Clutch Housing Axial Play (Wear Limit) - -
8) Push Rod Bending Limit 0.2 mm (0.008 in)
9) Oil Seal T y p e - Push Rod SDO-6.8-22-7
Oil Seal Type— Push Screw SO-10.5-15-3
345