Ryobi RCS3535A Bedienungsanleitung Seite 44

EN
FR DE ES
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
See Figures 45 - 47.
Check that the switch is in the
before you work on the saw.
IT PT NL SV DA NO
English(original instructions)
"0" position
FI HU CS RU RO PL
8VH RQO\ D ORZNLFNEDFN FKDLQ RQ WKLV VDZ 7KLV IDVW
cutting chain provides kickback reduction when properly
maintained.
For smooth and fast cutting, maintain the chain properly.
7KH FKDLQ UHTXLUHV VKDUSHQLQJ ZKHQ WKH ZRRG FKLSV DUH
small and powdery, the chain must be forced through the
wood during cutting, or the chain cuts to one side. During
maintenance of the chain, consider the following:
Q
Q
Q
Inspect the drive sprocket for wear or damage
when replacing the chain. If signs of wear or damage are
present in the areas indicated, have the drive sprocket
replaced by an authorised service centre.
If you do not fully understand the correct
procedure for sharpening the chain after reading the
instructions that follow, have the saw chain sharpened
by an authorised service centre or replace with a
recommended low-kickback chain.
See Figures 48 - 51.
Be careful to file all cutters to the specified angles and
to the same length, as fast cutting can only be obtained
when all cutters are uniform.
Q
Q
Q
Q
corner of the tooth.
Q
Q
Q
SL HR ET LT LV
.
SK BG
the front