Ryobi RCS3535A Bedienungsanleitung Seite 43

EN
FR DE ES
 RI WKH GLDPHWHU RI WKH ORJ
Give special attention to logs under stress to prevent the
bar and chain from pinching.
See Figure 31.
Begin on the top side of the log with the bottom of the
VDZ DJDLQVW WKH ORJ H[HUW OLJKW SUHVVXUH GRZQZDUG 1RWH
that the saw will tend to pull away from you.
See Figure 32.
Begin on the underside of the log with the top of the
VDZ DJDLQVW WKH ORJ H[HUW OLJKW SUHVVXUH XSZDUG 'XULQJ
under bucking, the saw will tend to push back at you.
Be prepared for this reaction and hold the saw firmly to
maintain control.
See Figures 33 - 34.
Q
Q
Q
Q
Q
Q
Q
Q
See Figure 35.
A springpole is any log, branch, rooted stump, or sapling
which is bent under tension by other wood so that it
springs back if the wood holding it is cut or removed.
2Q D IDOOHQ WUHH D URRWHG VWXPS KDV D KLJK SRWHQWLDO RI
springing back to the upright position during the bucking
cut to separate the log from the stump. Watch out for
springpoles — they are dangerous.
IT PT NL SV DA NO
English(original instructions)
FI HU CS RU RO PL
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, lubricant, grease,
etc.
All of the bearings in this product are lubricated with a
sufficient amount of high grade lubricant for the life of
WKH XQLW XQGHU QRUPDO RSHUDWLQJ FRQGLWLRQV 7KHUHIRUH QR
further lubrication is required.
See Figures 36 - 45.
Q
Q
SL HR ET LT LV SK BG