Kollmorgen AKD-N-DB Benutzerhandbuch Seite 583

AKD Benutzerhandbuch | 25.12.1 DIO9.INV to DIO11.INV
This parameter changes the logic sense of the differential input/output signals. When false, a logic 1
occurs when the + signal is higher than the – signal. When true, a logic 1 occurs when the – signal is
higher than the + signal.
The drive output parameters DOUTx.STATE and DOUTx.STATEU are not affected by changes in
this parameter. The drive input parameters DINx.STATE will be affected.
This parameter can be set at any time. It will be ignored unless DRV.EMUEMODE is set to 10.
Related Topics
DIN1.STATE TO DIN7.STATE (➜ S. 573)
DOUT1.STATE AND DOUT2.STATE (➜ S. 595)
DOUT1.STATEU AND DOUT2.STATEU (➜ S. 596)
DRV.EMUEMODE (➜ S. 649)
KOLLMORGEN | Dezember 2014 583