Kollmorgen AKD-N-DB Benutzerhandbuch Seite 781

AKD Benutzerhandbuch | 25.17.34 FB1.SELECT
Input Description
Value
Manually sets the type to SFD3. This value is only supported on model numbers AKD-
45
xxyyzz-NBxx. This value is only supported for firmware version 01-11-00-000 and later.
To use 2 wire SFD3 there must be an external feedback connection adapter between the 2
wires and the AKD X10 primary feedback connector. The feedback connection adapter
comes standard on Kollmorgen single motor cables.
Manually sets the type to Hiperface DSL. This value is only supported on model numbers
46
AKD-xxyyzz-NBxx.This value is only supported for firmware versions 01-09-00-000 and
later.
To use 2 wire Hiperface DSL there must be an external feedback connection adapter bet-
ween the 2 wires and the AKD X10 primary feedback connector. The feedback connection
adapter comes standard on Kollmorgen single motor cables.
50 This value is reserved and should not be used.
63 Manually sets the type to a simulated motor. This value is only supported on model numbers
AKD-xxyyzz-NBxx.
Related Topics
9.3 Rückführung 1 | FB1.IDENTIFIED (➜ S. 749)
KOLLMORGEN | Dezember 2014 781