AKD Benutzerhandbuch | 25.14.15 DRV.DIS
By querying the value of DRV.DISSOURCES (➜ S. 638), you can check whether the software ena-
ble bit is high (software enabled was issued by executing DRV.EN) or the software enable bit is low
(software disable was issued by executing DRV.DIS).
If DRV.DIS is commanded the emergency timeout is started. If the drive does not disable or activate
dynamic brake within DRV.DISTO (➜ S. 642), fault " F703" (➜ S. 293) is reported.
Related Topics
20.4 Fehler löschen
13.10 Kontrollierter Stopp
DRV.EN (➜ S. 660), DRV.DISSOURCES (➜ S. 638), DRV.ACTIVE (➜ S. 613), DRV.DISMODE
(➜ S. 636), DRV.DISTO (➜ S. 642)
KOLLMORGEN | Dezember 2014
635