Kollmorgen AKD-N-DB Benutzerhandbuch Seite 717

AKD Benutzerhandbuch | 25.14.70 DRV.WARNING1 to DRV.WARNING3
These parameters are holding registers where any active warnings will be displayed. A value of zero
represents that no warning is present. Non-zero values correspond to specific warning codes in the
drive (see fault and warning messages). The registers are populated in the order of when the warning
occurs (DRV.WARNING1, DRV.WARNING2, DRV.WARNING3, and so on).
Notes:
If DRV.WARNING1 value is 0, then the drive does not have any faults.
o
Only active warnings are shown. This is not a warning history.
o
These registers are an alternative to the string type parameter DRV.WARNINGS so
o
that fieldbuses and AKD BASIC user programs have integer-type parameters to access
to the details of the warnings in the drive.
Faults are not shown in the registers, only warnings.
o
Related Topics
DRV.FAULT1 to DRV.FAULT10 (➜ S. 666) | Modbus (➜ S. 343)
KOLLMORGEN | Dezember 2014 717