Kollmorgen AKD-N-DB Benutzerhandbuch Seite 601

AKD Benutzerhandbuch | 25.13.10 DOUT9.STATE to DOUT11.STATE
This parameter allows the user to see the actual level of the output signal, when the IO is set to output
mode. Parameter value is 0 if signal is low and 1 if signal is high. DIOx.INV can affect the signals dri-
ven onto the X9 connector.
This parameter can be read at any time. The value is only guaranteed to correspond to the output on
the X9 connector when DRV.EMUEMODE is set to 10 and the DIOX.DIR is 0.
Related Topics
DIO9.DIR to DIO11.DIR (➜ S. 584)
DIO9.INV to DIO11.INV (➜ S. 582)
DOUT9.STATEU to DOUT11.STATEU (➜ S. 602)
DRV.EMUEMODE (➜ S. 649)
KOLLMORGEN | Dezember 2014 601