Kollmorgen AKD-N-DB Benutzerhandbuch Seite 983

AKD Benutzerhandbuch | 25.29.1 MOTOR.AUTOSET
MOTOR.AUTOSET = 0, parameters are not loaded from motor memory and must be configured by the
user. Parameters which are not loaded from motor memory are always read-write.
Three conditions determine which parameters are calculated automatically by MOTOR.AUTOSET =
1. See the lists below to determine which parameters will automatically be configured from the motor
ID data.
The following parameters may be configured automatically when MOTOR.AUTOSET = 1:
MOTOR.BRAKE (➜ S. 984)
l
MOTOR.CTF0 (➜ S. 991)
l
MOTOR.ICONT (➜ S. 993)
l
MOTOR.INERTIA (➜ S. 1002)
l
MOTOR.IPEAK (➜ S. 1004)
l
MOTOR.KE (➜ S. 1006)
l
MOTOR.KT (➜ S. 1008)
l
MOTOR.LQLL (➜ S. 1012)
l
MOTOR.NAME (➜ S. 1014)
l
MOTOR.POLES (➜ S. 1020)
l
MOTOR.R (➜ S. 1022)
l
If the motor's FB1.MEMVER > 0.01, AKD will also configure:
MOTOR.PHASE (➜ S. 1015)
l
MOTOR.TBRAKEAPP (➜ S. 1028)
l
MOTOR.PHASE (➜ S. 1015)
l
MOTOR.VRATED (➜ S. 1051)
l
MOTOR.VOLTRATED (➜ S. 1049)
l
For firmware versions 01-09-00-000 and later, AKD will also configure:
MOTOR.RTYPE (➜ S. 1024)
l
MOTOR.TEMPFAULT (➜ S. 1037)
l
Related Topics
9.1 Motor
KOLLMORGEN | Dezember 2014 983