Herunterladen Inhalt Inhalt Diese Seite drucken

(Gilt Nur Für Nav1 Electromagnetic) Einfluss Weiterer Instrumente Auf Die Navigation; Probe-Registrierung - Storz NAV1 pico Gebrauchsanweisung

Vorschau ausblenden Andere Handbücher für NAV1 pico:
Inhaltsverzeichnis

Werbung

81
Aufstellen und
Bedienungshinweise
Bei der Instrumentenregistrierung wird die genaue
Geometrie des verwendeten Instruments geprüft.
Die Notwendigkeit zur Instrumentenregistrierung
wird durch den Hinweis „Please set probe onto
registration point" im Workflow-Fenster signalisiert.
(gilt nur für NAV1 electromagnetic)
Einfluss weiterer Instrumente
auf die Navigation
des KARL STORZ Navigationssystems gebracht,
so können diese unter Umständen die korrekte
Funktionsweise des Navigationssystems stören.
Überprüfen Sie deshalb stets den Einfluss weiterer
Instrumente auf das navigierte Instrumentenset.
Hierzu halten Sie z. B. die Navigationssonde
an eine Landmarke und bewegen das zu
Systems auf die Navigationssonde zu.
Verändert sich hierdurch die in den Bilddaten
dargestellte Position der Navigationssonde, so darf
das störende Instrument nicht gleichzeitig mit der
Navigation genutzt werden.
Entfernen Sie das störende Instrument aus dem
mit der Navigation fortfahren.

Probe-Registrierung

Für die Registrierung der Probe wird die
Spitze der Probe auf den Registrierpunkt des
Patiententrackers bewegt. Es erscheint eine rote
Registrier-„Uhr", die zunehmend grün wird.
Installation and operating
instructions
The precise geometry of the instrument used is
checked during instrument registration.
The need to perform instrument registration is
signalized by the message 'Please set probe onto
registration point' in the workflow window.
(only applies to NAV1 electromagnetic)
Influence of other instruments
on navigation
navigation system's measurement range, these
may impair the correct functioning of the navigation
system.
Thus, you must always check the influence of other
instruments on the navigated instrument set.
To do this, hold the navigation probe, for example,
against a landmark and move the instrument to
be examined in the system's measurement range
towards the navigation probe.
If the displayed position of the navigation probe
changes in the image data, the disruptive
instrument must not be used at the same time as
navigation.
Remove the disruptive instrument from the
navigation system's measurement range before
continuing with navigation.
Probe registration
In order to register the probe, the tip of the probe
is moved onto the registration point of the patient
tracker. A red registration 'clock' appears which
gradually turns increasingly green.

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

40 8000 01

Inhaltsverzeichnis