Herunterladen Inhalt Inhalt Diese Seite drucken

Aufstellen Und Bedienhinweise; Installation Des Nbu-Moduls; Zusammenbau Des Nbu-Stativs; Installation And Operating Instructions - Storz NAV1 pico Gebrauchsanweisung

Vorschau ausblenden Andere Handbücher für NAV1 pico:
Inhaltsverzeichnis

Werbung

20
Aufstellen und
Bedienungshinweise

Aufstellen und Bedienhinweise

Installation des NBU-Moduls

3
WARNUNG: Wurde das NBU-Modul
fallen gelassen, darf das System nicht
mehr eingesetzt werden. Der Service muss
benachrichtigt werden. Beschädigungen
des NBU-Moduls können zu Personen-
schäden und Zerstörung des Systems
führen.
Das NBU-Modul auf einer ebenen Fläche
platzieren und sicherstellen, dass das Gerät nicht
herunterfallen kann.
Das NBU-Modul kann entweder auf einem
Schwenkarm oder auf einem Gerätewagen
montiert werden.
Berücksichtigen Sie beim Aufstellen des
NBU-Moduls, dass die angeschlossene
Navigationskamera in der Nähe des
Operationsgebiets positioniert werden muss.
Platzieren Sie das NBU-Modul so, dass es jederzeit
problemlos vom Stromnetz getrennt werden kann.

Zusammenbau des NBU-Stativs

Das 5-Stern-Stativ mit den mitgelieferten
Schrauben an die Basis montieren.
Nicht auf das montierte Stativ treten und das Stativ
nicht mit schweren Objekten belasten.
3
WARNUNG: Das NBU-Fahrstativ muss mit
einer Neigung von weniger als fünf Grad
installiert oder auf ebenen Flächen bewegt
werden.
Installation and operating
instructions
Installation and operating
instructions

Installing the NBU module

3
WARNING: If the NBU module has been
dropped, the system must no longer be
used. Service must be informed. Damage
to the Navigation Base Unit can result in
injury to persons and damage to the
system.
Place the NBU module on a flat surface and ensure
that it is prevented from falling down.
The NBU module can be mounted on a shelf of a
surgical pendant or an equipment cart.
While placing the NBU module, keep in mind
that the connected navigation camera has to be
positioned in proximity to the operating field.
Position the NBU module so that it can easily be
disconnected from the mains at any time.
Assembly of the Mobile Stand
Mount the five-foot stand onto the base using the
screws supplied.
Do not step on or place heavy objects on the
assembled stand.
3
WARNING: The NBU mobile stand must
be installed or moved on even planes with
an inclination of less than 5 degrees.
3
3

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

40 8000 01

Inhaltsverzeichnis