Operating Mode - ECOLAB EcoAdd Betriebsanleitung

8.7

Operating mode

[Select Operating mode]
Selecting the operating mode sets whether the pump is operated using internally set
values (Manual, Timer) or if an external signal determines the dosage rate ([Pulse],
[Current]).
Fig. 19: Overview: [Operating mode]
Factory setting: Manual
1.
[Call the Main menu] (see
[Operating mode] (item 1).
2.
[Select Operating mode] (item 2), see:
Ä Chapter 8.7.1 ' [Operating mode] [Manual]' on page 67
n
n Ä Chapter 8.7.2 '[Operating mode] [Pulse]' on page 70
Ä Chapter 8.7.3 '[Operating mode] [Current]' on page 81
n
Ä Chapter 8.7.4 '[Operating mode] [Timer]' on page 85
n
3.
Press the Back button
ð The screen changes to: [Main menu].
4.
Press the Back button
ð The screen changes back to the [Operating display].
8.7.1
[Operating mode] [Manual]
In [Manual] [Operating mode], the pump operates with the selected litre capacity after
being switched on (without further conditions).
We recommend combining this [Operating mode] with an external dosing release.
When you activate the release function (see
on page 69 ), the pump does not start until a closed contact is present on the
input terminals defined for the release (see
on page 68 ).
The dosage rate can also be set or changed while the pump is operational (see
dosage rate/litre capacity' on page 70 ).
1
Ä Chapter 8.5 'Main menu' on page 63 ) and choose
(item 3) to save your settings.
again.
3
2
Ä '[Activate Dosing release]'
Ä 'Terminal assignment for dosing release'
67
Control/software
Ä 'Set the
MAN046939 Rev. 6-10.2021