ECOLAB EcoAdd Betriebsanleitung Seite 277

[Selecting/setting Operating mode] [Pulse] [Quantity]
When using the [Quantity] pulse processing option, you enter the desired quantity per
input pulse. The pump software then automatically calculates the required metering speed
of the pump.
3
2
10
Fig. 26: [Operating mode]: [Pulse] [Quantity]
1.
[Call the main menu]:
2.
[Select Operating mode] - [Pulse] (item 2).
3.
[Press the Next]
ð The screen for selecting 'pulse processing' is displayed.
4.
'Select Pulse processing' [Quantity] (item 4).
5.
[Press the Next]
ð The screen for selecting the [Quantity] unit (item 6) is displayed.
6.
Select the required unit [l/Pulse], [ml/Pulse] or [G/Pulse] (item 6).
7.
[ Press the Next]
ð The screen changes to the 'Pulse memory' prompt (item 8).
8.
Select whether the 'Pulse memory' (item 8) is to be used.
ð If you select the 'Pulse memory' , a
9.
Press button (item 9).
ð The settings are saved. The screen switches back to the [Operating mode]
overview and shows the mode that was set (item 10).
4
5
Ä Chapter 8.5 'Main menu' on page 63
button (item 3).
button (item 5).
button (item 7).
73
Control/software
7
6
appears in the selection box.
MAN046939 Rev. 6-10.2021
9
8