ECOLAB EcoAdd Betriebsanleitung Seite 299

[Setting the Access code]:
3
Fig. 42: Configuration: [Access code]
Factory setting: No access code
[Setting the Access code]:
1.
[Call the main menu]:
2.
[Select Configuration]:
3.
[Select Access code]
ð Screen change: 'Access code' 'Administrator (A)'
4.
[Use the slider to enter the access code].
5.
[Press the Next button]
ð Screen change: 'Access code' 'Operator (O)'
6.
[Use the slider to enter the access code].
7.
Press the button to save the setting.
ð The screen switches to the [Configuration] overview.
8.
Press the button to return to the [Main menu].
9.
Press the button to return to the [Operating display].
If the [Access code] has been entered in order to define pump settings, a
clock appears on the operating display (item 1). It runs backwards for 15
minutes and then blocks the pump again automatically. If the menu is opened
repeatedly within the running time period, this time period begins again from
the start.
The pump can be locked immediately by "tapping" the "clock symbol", without
the time elapsing.
If only the [Access code] for the Administrator (A) is set, no code letter is
displayed in the clock symbol. If both access codes are set, the code letter
belonging to the current login (Administrator (A) or Operator (O)) will always
appear.
4
Ä Chapter 8.5 'Main menu' on page 63
Ä Chapter 8.8 'Configuration' on page 89
.
If an [Access code] has been set, this is visible on
the display while the pump is in operation:
The activated [Access code] is indicated by a closed
padlock symbol
95
Control/software
5
6
on the operating display (item 2).
MAN046939 Rev. 6-10.2021
7