ECOLAB EcoAdd Betriebsanleitung Seite 279

[Selecting/setting Operating mode] [Pulse] [Batch concentration]
When using the [Batch concentration] pulse processing type, only the required active
substance concentration is selected based on the pulse interval of the selected water
meter and the chemical concentration of the medium to be metered.
The pump software uses this information to calculate the required metering speed
automatically.
3
2
13
11
12
22
Fig. 28: Operating mode: [Pulse] [Batch concentration]
1.
[Call the main menu]:
2.
[Select Operating mode] - [Pulse] (item 2).
3.
[Press the Next]
ð The 'Pulse processing' screen is displayed.
4.
'Select Pulse processing' [Batch concentration] (item 4).
5.
[Press the Next]
ð The screen for the unit for [Batch concentration] (item 6) is displayed.
6.
Select the required unit for [Batch concentration] (item 6).
7.
[Press the Next]
ð The 'Pulse interval' screen (item 8) is displayed.
8.
Enter the pulse interval of the flow meter being used.
Select the field for entering the value to the left of the decimal point (item 9).
ð The colour changes to dark blue, which indicates that the field is ready for input.
9.
Set the value to the left of the decimal point using the slider.
10. Select the field for entering the value after the decimal point (item 11).
ð The colour changes to dark blue, which indicates that the field is ready for input.
11. Use the slider to set the value after decimal point.
12. [Press the Next]
ð The 'Chemical conc.' screen (item 14) is displayed.
13. Enter the concentration of the metering solution in % (item 14).
Select the field for entering the value to the left of the decimal point (item 15).
ð The colour changes to dark blue, which indicates that the field is ready for input.
5
4
14
15
16
Ä Chapter 8.5 'Main menu' on page 63
button (item 3).
button (item 5).
button (item 7).
button (item 13).
75
Control/software
7
6
9
19
17
18
MAN046939 Rev. 6-10.2021
8
10
21
20