ECOLAB EcoAdd Betriebsanleitung Seite 332

Control/software
8.12 Import and export functions
The configuration data can be updated via a USB stick to load the data to other pumps,
for example. This simplifies setting work when using multiple pumps of the same version
within a metering line as not every individual pump needs to be configured.
Export to USB data carrier:
We recommend using an empty or newly formatted USB stick to avoid
problems when saving data!
You must use a suitable USB flash drive in order for the USB export and import
function to work correctly. Use a USB (up to approx. 8 GB) formatted to use
[FAT32].
If the desired function cannot be called, the USB drive has not been detected
properly and should be formatted as described above. If the function is still not
available after formatting, we recommend that you change the USB drive.
Fig. 72: Import/export of the configuration
The menu for performing an import and export is displayed after you insert a USB stick
and call the Configuration menu item in the main menu.
Preparations for importing and exporting databases:
1.
Insert the USB stick (item 1) in the USB socket on the pump.
2.
Press the menu button
ð The [Main menu] is displayed.
3.
In the [Main menu], select [Configuration] (item 3).
ð Screen changes to [Configuration] USB export / USB import (item 4).
MAN046939 Rev. 6-10.2021
1
2
(item 2).
128
3
4