ECOLAB EcoAdd Betriebsanleitung Seite 272

Control/software
Terminal assignment for dosing release
WARNING!
The EcoAdd should not be controlled by switching the power supply on/
off.
Each time the pump is switched on, its electronics require approx. 500 msec.
to start up. If the power supply is interrupted during the start-up process, this
may lead to a malfunction. Please use the dosing release to control the pump
(see
Fig. 20: Terminal assignment for dosing release: Zero-potential contact
[Selecting/setting Operating mode] [Manual]
Fig. 21: [Operating mode] [Manual]
1.
[Call the Main menu] (see
[Operating mode] (item 1).
ð Screen switches to the [Operating mode] selection level.
2.
[Select Operating mode] 'Manual' .
3.
Press the Back button
ð The screen changes to: [Main menu].
4.
Press the Back button
ð The screen changes back to the [Operating display].
MAN046939 Rev. 6-10.2021
Ä Chapter 8.8.7 'Dosing release' on page 99 ).
1
Ä Chapter 8.5 'Main menu' on page 63 ) and choose
(item 3) to save your settings.
again.
3
2
68