ECOLAB EcoAdd Betriebsanleitung Seite 368

Maintenance
EcoAdd - entering maintenance mode when no access code is being used
7
Fig. 91: EcoAdd - entering maintenance mode when no access code is being used
1.
On the operating screen, press the maintenance symbol ( ,
2.
If an [access code] is not active
pump service' / 'Maintenance?'
3.
Cancel maintenance: Press the Cancel button
ð The query screen closes, maintenance mode is not started and the operating
screen is displayed.
4.
Start maintenance: Press the OK button
ð The EcoAdd puts the motor and the diaphragm into the maintenance position.
5.
A prompt screen 'Maintenance: Switch off pump!' is displayed.
6.
Switch off the EcoAdd using the 'ON/OFF button'
power supply. Then reconnect the mains power and switch the pump on again.
7. Carry out the maintenance.
8.
After switching the EcoAdd back on, the prompt screen 'Maintenance performed?' is
displayed.
9. Do not confirm the completion of maintenance: Press the Cancel button
10. The notification screen 'Maintenance not completed!' is displayed.
The internal counter for the maintenance work performed(
8.10 'Operating data' on page 126 ) is not increased.
After confirming this notification screen, the operating screen (item 13) is displayed
and the EcoAdd is ready for operation.
11. Confirm completion of maintenance: Press the OK button
12. The notification screen 'Maintenance completed!' is displayed.
The internal counter for the maintenance work performed(
8.10 'Operating data' on page 126 ) is increased.
After confirming this notification screen, the operating screen (item 13) is displayed
and the EcoAdd is ready for operation.
MAN046939 Rev. 6-10.2021
2
1
9 11
8
To access the maintenance mode, press and hold the displayed
maintenance signal for around 3 seconds.
3
4
10
, the pump shows the query screen 'Perform
.
.
and then disconnect from the
164
6
5
12
13
or ).
.
Ä Chapter
.
Ä Chapter