ECOLAB EcoAdd Betriebsanleitung Seite 280

Control/software
14. Use the slider to set the value to the left of the decimal point.
15. Select the field for entering the value after the decimal point (item 17).
ð The colour changes to dark blue, which indicates that the field is ready for input.
16. Use the slider to set the value after decimal point (item 18).
17. Press the Next button
ð The screen changes to the 'Pulse memory' prompt (item 20).
18. Select whether the 'Pulse memory' is to be used.
ð If you select the 'Pulse memory' , a
19. Press button
ð The screen switches back to the [Operating display] (item 22) and displayed the
newly set unit.
[Setting Operating mode] [Pulse] [Concentration] [%] or [ppm]
[Setting %]
1
Fig. 29: [Changing the Pulse] [Concentration] [%] at the operating level
1.
On the screen, press the displayed [Concentration] [%] for approx. 2 seconds.
2.
This step can be skipped if there is no password query here.
ð The screen switches to the view for setting the [%] value.
ð The number to the left of the decimal point is already set and can be changed.
3.
[Use the slider to set the %] value to the left of the decimal point.
4.
Select the field for entering the value after the decimal point.
ð The background field colour changes to dark blue, which indicates that the field is
ready for input.
5.
[Use the slider to set the %] value after the decimal point.
6.
[Press the Menu button]
ð The settings are saved and the pump switches back to the operating screen.
The new 'Application concentration ' is displayed on the operating screen.
MAN046939 Rev. 6-10.2021
(item 19).
(item 21).
2
If you have activated the [access code]
Ä Chapter 8.5 'Main menu' on page 63 .
We strongly recommend setting the access code!
Ä Chapter 8.8.4 'Access code' on page 93
.
appears in the selection box.
3
, note the following:
76
6
4
5