ECOLAB EcoAdd Betriebsanleitung Seite 356

Operation
Räder umsteckenContainer change with preset [Man. acknowledge] preset
Fig. 85: Empty signal: Changing a container
1.
On the operating screen, press 'Empty signal indicator'
seconds.
2.
If a password prompt is displayed, the access code must be entered (
8.8.4 'Access code' on page 93 ).
ð The screen switches to the information screen for the 'Empty signal' .
3. Perform a container change:
- Remove the suction lance (item 3) from the empty container.
- Replace the empty container with a full container.
- Place the suction lance (item 3) back into the full container.
ð The pump detects the new fill level via the connected suction lance.
4.
Following a detected container change, the pump automatically resumes operation
with the last settings.
MAN046939 Rev. 6-10.2021
1
DANGER!
It is essential that the personal protective equipment (PPE) described on
the product data sheet (safety data sheet) for the metering medium is
used.
WARNING!
Risk of slipping due to fluid in the operation and provisioning area!
– Wear non-slip, chemically resistant shoes when working.
– Place product containers in a tank to prevent a slipping hazard caused
by leaking fluids.
ENVIRONMENT!
Immediately soak up any leaking liquids with a suitable binding agent and
dispose of properly.
2
3
152
4
(item 1) for approx. 3
Ä Chapter