ECOLAB EcoAdd Betriebsanleitung Seite 290

Control/software
[Selecting/setting Operating mode] [Timer] [Seven-day programme]
2
8
16
Fig. 35: [Timer] [Seven-day programme]
1.
[Call the main menu]:
2.
[Select Operating mode] - [Timer].
3.
[Press the Next] button
ð The screen changes to the selection of the timer interval (seven-day programme)
4.
[Select Seven-day programme].
ð The screen change to the selection: 'Time' - [Seven-day programme]
5.
[Press the Next] button
6.
Select the time (up to seven different seven-day programmes are possible).
ð The screen changes to the setting 'Timer 1' : 'Switching point'
7.
Pressing the
ð The screen switches back to the [Operating mode] overview.
8.
Use the slider to set the time/hours.
9.
Select time/minutes.
10. Use the slider to set the time/minutes.
11. [Press the Next] button
ð The screen changes to the setting: 'Pulse duty factor'
12. Use the slider to set the minutes.
13. Select seconds.
14. Use the slider to set the seconds.
15. [Press the Next] button
ð The screen changes to the setting: 'Power'
16.
'Use the slider to set the litre capacity' to the left of the decimal point.
17. Select the field for entering the value after the decimal point.
ð The colour changes to dark blue, which indicates that the field is ready for input.
18.
'Use the slider to set the litre capacity' after the decimal point.
19. [Press the Next] button
ð The screen changes to the setting: 'Weekday'
MAN046939 Rev. 6-10.2021
5
3
11
9
10
19
17
18
Ä Chapter 8.5 'Main menu' on page 63
.
.
button closes the seven-day programme without saving.
.
.
.
86
7
4
6
12
20
15
13
14
21
20