ECOLAB EcoAdd Betriebsanleitung Seite 302

Control/software
8.8.6 Auto start
The [Auto start] function determines whether the pump is set to 'Pause' when the mains
connection is re-established following a power cut or if the pump should immediately
recommence functioning in the configured operating mode.
CAUTION!
Danger of the textvar object does not exist
If the autostart function is active, the textvar object does not exist
operator is responsible for taking suitable measures to ensure that an
unwanted start-up of the textvar object does not exist is prevented when
the mains power is restored after a power cut.
4
Fig. 45: Configuration: [Auto start]
Factory setting: Without auto start
[Set Auto start]:
1.
[Call the main menu]:
2.
[Select Configuration]:
3.
Use the scrollbar to go to the [Auto start] menu item.
4.
[Select Auto start]
ð The screen switches to the [Auto start] selection.
5.
If required, select the 'With Autostart' selection box.
ð A tick is shown in the selection field.
6.
Press the
ð The setting is saved, and the screen switches back to the configuration overview.
7.
Press the
8.
Press the
MAN046939 Rev. 6-10.2021
3
5
Ä Chapter 8.5 'Main menu' on page 63
Ä Chapter 8.8 'Configuration' on page 89
button.
button to return to the [Main menu].
button to return to the [Operating display].
98
6