ECOLAB EcoAdd Betriebsanleitung Seite 274

Control/software
Set the dosage rate/litre capacity
The following screens show example displays for a pump with capacity of
11 l/h. Specifications and information shown will differ for other pump sizes.
Fig. 23: Set the dosage rate/litre capacity
1.
On the [Operating screen], press the displayed 'litre capacity' .
ð The screen switches to the screen for setting the 'Litre capacity' .
2.
'Use the slider to set the litre capacity' to the left of the decimal point.
3.
Select the field for entering the value after the decimal point.
ð The colour changes to dark blue, which indicates that the field is ready for input.
4.
'Use the slider to set the Litre capacity' after the decimal point.
5.
Press the
ð The operating screen shows the newly set 'Litre capacity' .
8.7.2
[Operating mode] [Pulse]
In [Pulse] [Operating mode], the metering quantity of the pump is determined by an
incoming pulse rate from a connected peripheral device (e.g. water meter).
Pulse memory:
If the incoming pulse rate is higher than the max. pulse rate that can be processed by the
pump, it is possible to store the unprocessed pulses.
The stored pulses are processed once no more external pulses are being issued. This
means that the pump continues to function even though no external running conditions
apply.
In the worst-case scenario, this can lead to metering taking place into a closed system,
resulting in impermissibly high pressure in the system.
This must be prevented through appropriate safety measures.
The memory content can be deleted by activating the metering lock or switching off the
pump.
MAN046939 Rev. 6-10.2021
1
2
To access the setting, press and hold the 'Litre capacity' shown on the
display, for around 3 seconds.
button to save your changes and return to the [Operating display].
3
70
6
4
5