ECOLAB EcoAdd Betriebsanleitung Seite 355

Container change with [Auto acknowledge] preset
Fig. 84: Container change for (Auto acknowledge) preset
1.
If the metering pump detects an empty container via a connected suction lance
with integrated empty signal detection (item 1), this is displayed by the empty signal
symbol in red.
If the container size has been set as described in
8.8.13 'Container size' on page 113 , for pumps WITHOUT a Bluetooth
PCB a canister
empty signal symbol.
ð The pump stops operating.
2. Perform a container change:
- Remove the suction lance (item 2) from the empty container.
- Replace the empty container with a full container.
- Place the suction lance (item 2) back into the full container.
DANGER!
It is essential that the personal protective equipment (PPE) described on
the product data sheet (safety data sheet) for the metering medium is
used.
WARNING!
Risk of slipping due to fluid in the operation and provisioning area!
– Wear non-slip, chemically resistant shoes when working.
– Place product containers in a tank to prevent a slipping hazard caused
by leaking fluids.
ENVIRONMENT!
Immediately soak up any leaking liquids with a suitable binding agent and
dispose of properly.
ð The pump detects the new fill level via the connected suction lance.
3.
Following a detected container change, the pump automatically resumes operation
with the last settings.
2
1
is displayed as the empty signal symbol instead of the
151
Operation
3
Ä Chapter
MAN046939 Rev. 6-10.2021