ECOLAB EcoAdd Betriebsanleitung Seite 389

14.2 Upgrades
Installing a Bluetooth interface
To be able to monitor and control the pump using a suitable smartphone, you must fit a
Bluetooth PCB.
The pump can be ordered both with and without Bluetooth PCB. For pumps
without a factory-fitted Bluetooth PCB, this can be retrofitted. See
13.3 'Accessories' on page 181 .
DANGER!
Risk of electric shock
Pay attention to disconnect the power supply immediately and to secure
against accidental switch-on!
The following section explains how to fit the Bluetooth PCB.
Fig. 106: Upgrading with Bluetooth PCB
Order number for Bluetooth PCB: Article no.: 252080 (EBS No.: on request)
1.
Loosen the lid screws (4 x, item 1) using a Torx wrench (TX25).
2.
Remove the lid (item 2) by pulling it forward.
3.
Remove the connectors numbered 4-5, 6-8, 10-13 and 14-17 to create room to
install the Bluetooth PCB (item 4).
4.
Push the Bluetooth PCB (item 4) into the slot.
5.
Insert the connectors 4-5, 6-8, 10-13 and 14-17 again in the correct order.
6.
Check the rear front lid seal for contamination and clean as necessary.
7.
Place the front lid (item 2) on the housing in the correct position.
8.
Tighten the fastening screws.
ð
1
The tightening torque for the fastening screws on the control unit
is approx. 1 Nm. To prevent damage to the thread, we recommend
tightening the screws by hand.
Once the Bluetooth PCB has been installed correctly, the Bluetooth
symbol ( Fig. 106 , item 9) appears in the lower right of the display
when the pump is switched on.
Conversion, upgrade, repair
4
2
3
185
Ä Chapter
8
MAN046939 Rev. 6-10.2021
9