Inhaltsverzeichnis
Werbung
P P r r e e v v e e n n t t i i v v e e m m a a i i n n t t e e n n a a n n c c e e
R R e e g g u u l l a a r r i i n n s s p p e e c c t t i i o o n n a a n n d d a a d d j j u u s s t t m m e e n n t t s s
M M a a i i n n t t e e n n a a n n c c e e i i n n t t e e r r v v a a l l s s
This schedule is a general guide to maintenance. The required maintenance schedule may vary based on:
•
Call volume
•
Weather
•
Terrain
•
Geographical location
•
Individual usage
If you are not sure how or when to perform these checks, contact your Stryker Service Technician.
When you perform P P o o w w e e r r - - L L O O A A D D preventive maintenance checks, you must perform a preventive maintenance check on
its corresponding P P o o w w e e r r - - L L O O A A D D compatible cot and the wheel guide assembly option (if applicable) to confirm operability of
the entire system.
P P o o w w e e r r - - L L O O A A D D c c o o m m p p a a t t i i b b l l e e c c o o t t m m a a i i n n t t e e n n a a n n c c e e
Wear items that may require replacement on the P P o o w w e e r r - - L L O O A A D D compatible cot include the cot arm spacer (6500-002-123),
base dead stop (6085-001-094), and load wheel pin (6500-002-104).
W W h h e e e e l l g g u u i i d d e e a a s s s s e e m m b b l l y y o o p p t t i i o o n n m m a a i i n n t t e e n n a a n n c c e e ( ( i i f f a a p p p p l l i i c c a a b b l l e e ) )
To preserve P P o o w w e e r r - - L L O O A A D D fastener functionality, make sure that the wheel guide is functional and its structure has not
been compromised. The wheel guide rail system assists the P P o o w w e e r r - - L L O O A A D D system in loading the cot. If the wheel guide has
been compromised, replace it immediately.
N N o o t t e e - - The P P o o w w e e r r - - L L O O A A D D maintenance schedule is based on 10 calls per day. Adjust the routine maintenance schedule to
your actual service usage.
E E v v e e r r y y m m o o n n t t h h o o r r t t w w o o h h o o u u r r s s
Inspect these items every month or two hours of motor run time, whichever comes first.
C C h h e e c c k k
Lock location
E E v v e e r r y y t t h h r r e e e e m m o o n n t t h h s s o o r r s s i i x x h h o o u u r r s s
Inspect these items every three months or six hours of motor run time, whichever comes first.
C C h h e e c c k k
Loose fasteners
Battery terminal screws
Transfer assembly and anchor assembly
6390-809-005 Rev AA.0
R R o o u u t t i i n n e e
Clean debris from the foot end lock location on the transfer
R R o o u u t t i i n n e e
Replace if loose
Tighten loose screws (torque to 9 in-lb)
Clean debris from the top of the transfer assembly and
anchor assembly
49
EN
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
