Stryker Power-LOAD Bedienungsanleitung Seite 11

C C A A U U T T I I O O N N
• Improper usage of the product can cause injury to the patient or operator. Operate the product only as described in this
manual.
• Do not modify the product or any components of the product. Modifying the product can cause unpredictable operation
resulting in injury to patient or operator. Modifying the product also voids its warranty.
• Do not break the cot inductive charge housing when you install the transfer assembly.
• Always make sure that the wires rest inside of the floor plate pocket and are not pinched by the anchor assembly when
you install the anchor assembly.
• The manual overrides allow the P P o o w w e e r r - - L L O O A A D D system to move freely.
• Always charge the battery before you place the product into service. An uncharged or depleted battery may cause poor
product performance.
• Do not slam the cot into the trolley when you load the cot to avoid the risk of equipment damage.
• Do not push the cot into the vehicle patient compartment until the cot base is fully retracted.
• Do not push the cot into the vehicle patient compartment until you fully retract the cot base.
• Do not let go of the manual release until the cot locks into position at the foot end. If you let go too early, then the cot
base may prevent the cot from locking into P P o o w w e e r r - - L L O O A A D D .
• Do not spray directly underneath the trolley up in to the trolley mechanism. Water could gain ingress into the trolley
housing and may accelerate corrosion or degrade operation.
• Do not clean, service, or perform maintenance while the product is in use.
• This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at their expense. In the event of interference, please relocate or
reorient the P P o o w w e e r r - - L L O O A A D D system or interfering product.
• Always relocate or reorient the P P o o w w e e r r - - L L O O A A D D system or interfering product in the event of interference. This device
complies with Part 18 of the FCC Rules.
• Do not use portable RF communications equipment (including peripherals such as antenna cables and external
antennas) closer than 30 cm (12 in.) to any part of the P P o o w w e e r r - - L L O O A A D D system, including cables specified by the
manufacturer. Otherwise, degradation of the performance of this equipment may result.
• The emissions characteristics of this equipment make it suitable for use in industrial areas and hospitals (CISPR 11
class A). This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area (for which CISPR 11 class B is normally required) is likely to cause harmful interference,
in which case the user will be required to correct the interference at their expense. In the event of interference, please
relocate or reorient the P P o o w w e e r r - - L L O O A A D D system or interfering product.
6390-809-005 Rev AA.0 5 EN