Stryker Power-LOAD Bedienungsanleitung Seite 50

2. Grasp the cot frame at the foot end to pull the cot out of the vehicle patient compartment.
For Model 6500/6506 and 6510/6516 with P P o o w w e e r r - - L L O O A A D D option:
• Operator 1: Grasp the cot frame at the foot end. While you support the weight of the cot, guide and pull the cot out
of the vehicle patient compartment. Press and hold the extend (+) button on the cot control switch to extend the cot
until the cot wheels rest on the ground.
• Operator 2: Grasp the outer rail to stabilize the cot.
For Model 6085/6086 with the P P o o w w e e r r - - L L O O A A D D option:
• Operator 1: Grasp the cot frame.
• Operator 2: Grasp the base frame where indicated, lift slightly, and lower the base frame to its fully extended
position while Operator 1 squeezes and holds the cot manual release. Make sure that the cot wheels are on the
ground.
• Operator 1 (foot end): Release the cot manual release to lock the undercarriage into the extended position.
3. Press the manual release button on the P P o o w w e e r r - - L L O O A A D D control panel (Figure 45).
F F i i g g u u r r e e 4 4 5 5 – – P P r r e e s s s s t t h h e e m m a a n n u u a a l l r r e e l l e e a a s s e e b b u u t t t t o o n n
4. Lift one of the manual cot release handles at the head end of P P o o w w e e r r - - L L O O A A D D to unlock the cot (Figure 46).
5. Raise the lifting arms and guide the trolley into the vehicle patient compartment until the arms are far enough in to not
interfere with the vehicle doors.
6. Remove the vehicle from service to diagnose and repair P P o o w w e e r r - - L L O O A A D D after the call.
EN 44
F F i i g g u u r r e e 4 4 4 4 – – P P r r e e s s s s a a n n d d h h o o l l d d t t h h e e r r e e l l e e a a s s e e l l e e v v e e r r
F F i i g g u u r r e e 4 4 6 6 – – U U n n l l o o c c k k t t h h e e c c o o t t
6390-809-005 Rev AA.0