N N o o t t e e - - If P P o o w w e e r r - - L L O O A A D D will not be in use for a week or more, press the main power button to turn the product off and avoid

draining the battery. You may need to turn the product on and then off to make sure that P P o o w w e e r r - - L L O O A A D D is off and not in

sleep mode.

L L o o a a d d i i n n g g P P o o w w e e r r - - L L O O A A D D w w i i t t h h m m a a n n u u a a l l o o p p e e r r a a t t i i o o n n s s

1. Make sure that P P o o w w e e r r - - L L O O A A D D is located at the head end of the vehicle patient compartment with the lifting arms down.

2. Push the cot into the vehicle patient compartment until the cot locks into P P o o w w e e r r - - L L O O A A D D .

3. Make sure that the cot is locked into P P o o w w e e r r - - L L O O A A D D by firmly pulling side to side on the foot end of the cot.

4. For additional loading instructions, see Loading a cot into a vehicle manually (Power-PRO power loss) (page 47).

U U n n l l o o a a d d i i n n g g P P o o w w e e r r - - L L O O A A D D w w i i t t h h m m a a n n u u a a l l o o p p e e r r a a t t i i o o n n s s

1. Press and hold the release lever at the foot end of the P P o o w w e e r r - - L L O O A A D D system.

2. Pull to remove the cot from the vehicle patient compartment.

Load

Unload

F F i i g g u u r r e e 2 2 6 6 – – M M a a n n u u a a l l o o p p e e r r a a t t i i o o n n s s

Improper usage of the Power-LOAD system or

any accessory can cause injury to the patient or

operator. Operate the Power-LOAD system and

accessories only as described in the manuals.

For Manual Operations, the operator must

support the foot end of the cot.