7. Press the up (↑) button on the P P o o w w e e r r - - L L O O A A D D control panel (Figure 50) to raise the lifting arms to the highest position.

N N o o t t e e - - The cot legs do not retract.

F F i i g g u u r r e e 4 4 9 9 – – L L o o c c k k t t h h e e w w h h e e e e l l p p i i n n s s i i n n t t o o p p o o s s i i t t i i o o n n

8. Operator 1 (foot end): Grasp the cot frame at the foot end. Squeeze and hold the cot manual release.

9. Operator 2 (side): Grasp the base frame. After the foot end operator squeezes the cot manual release, retract the

undercarriage with one hand and stabilize the cot with your other hand.

10. Both operators: Push the cot into the vehicle patient compartment, until the lifting arms lower and the cot locks into

P P o o w w e e r r - - L L O O A A D D .

11. Operator 1: Continue to squeeze and hold the cot manual release.

12. Make sure that the cot is locked into P P o o w w e e r r - - L L O O A A D D by firmly pulling side to side on the foot end of the cot.

13. After the call, remove the cot from service to diagnose and repair the P P o o w w e e r r - - P P R R O O cot.

N N o o t t e e - - P P o o w w e e r r - - L L O O A A D D automatically charges the S S M M R R T T Pak battery when the cot is locked into P P o o w w e e r r - - L L O O A A D D in the

transport position (no cable or connectors required). The cot battery LED indicator momentarily flashes green to signify

that it is charging.

F F i i g g u u r r e e 5 5 0 0 – – P P r r e e s s s s t t h h e e u u p p b b u u t t t t o o n n t t o o r r a a i i s s e e t t h h e e l l i i f f t t i i n n g g

a a r r m m s s

6390-809-005 Rev AA.0

Inhaltsverzeichnis