Stryker Power-LOAD Bedienungsanleitung Seite 47

F F i i g g u u r r e e 3 3 4 4 – – L L o o w w e e r r t t h h e e l l i i f f t t i i n n g g a a r r m m s s
8. Lift one of the two manual cot release handles at the head end of the trolley to unlock the cot (Figure 35).
9. Raise the lifting arms and guide the trolley into the vehicle patient compartment until the arms are far enough in to not
interfere with the vehicle doors.
L L o o a a d d i i n n g g a a P P o o w w e e r r - - P P R R O O c c o o t t i i n n t t o o a a v v e e h h i i c c l l e e w w i i t t h h t t h h e e P P o o w w e e r r - - L L O O A A D D o o p p t t i i o o n n
W W A A R R N N I I N N G G
• Always load or unload an occupied cot into a vehicle with a minimum of two trained operators.
• Always load the P P o o w w e e r r - - L L O O A A D D compatible cot into the vehicle patient compartment before all occupants.
C C A A U U T T I I O O N N - - Do not slam the cot into the trolley when you load the cot to avoid the risk of equipment damage.
1. Lift the vehicle bumper to the raised position, if equipped.
2. Raise the lifting arms to guide and pull the trolley out of the vehicle patient compartment (Figure 36).
F F i i g g u u r r e e 3 3 6 6 – – G G u u i i d d e e t t r r o o l l l l e e y y o o u u t t o o f f v v e e h h i i c c l l e e
3. Press and hold the extend (+) button on the cot control switch to extend the cot undercarriage to the set load height
(Figure 37).
4. Fully extend and lock the cot retractable head section before you load the cot into P P o o w w e e r r - - L L O O A A D D .
5. Push the cot into P P o o w w e e r r - - L L O O A A D D until the cot load wheel pins lock into position (Figure 38). Make sure that the cot is
aligned with the lifting arms when you load the cot.
6390-809-005 Rev AA.0
F F i i g g u u r r e e 3 3 5 5 – – U U n n l l o o c c k k t t h h e e c c o o t t
F F i i g g u u r r e e 3 3 7 7 – – S S e e t t t t h h e e l l o o a a d d h h e e i i g g h h t t
41 EN