Sport 1100 I And Daytona Rs - MOTO GUZZI V10 CENTAURO Werkstatt-Handbuch

9.2

SPORT 1100 I AND DAYTONA RS

NOTE: The disassembly procedure and
operations are the same for both models.
To disassemble, proceed as follows:
• Remove the passenger saddle by releasing the
lock «A» - Fig. 09-09 using the same wrench of the
ignition switch;
• Remove the driver saddle using a 6 mm Allen wrench, unscrew from both sides the pin screws «B» - Fig. 09-10
which can be accessed through the holes «C» - Fig. 09-10/A located on the tail side;
B
• Unscrew the screws «D» - Fig. 09-11 from both
sides of the motorcycle, then remove the tail;
• Unscrew the screws «E» - Fig. 09-11 which fasten
the fairing top to the frame.
NOTE: When unscrewing the above screws,
the driving mirrors are released too; remove
them.
• Unscrew the screws «F» - Fig. 09-11 which fasten
the fairing from both sides, then extract the fairing;
• Close the fuel cock «G» - Fig. 09-12;
• Disconnect the electric connection of the fuel
reserve indicator «H» - Fig. 09-12;
• Disconnect the fuel pipes from the cock «G» -
Fig. 09-12 and from the pressure adjuster «I» -
Fig. 09-13;
• Unscrew the screw «L» - Fig. 09-12, disconnect
the exhaust pipe and remove the tank;
40
A
09-10
C
F
D
L
H
G
09-09
09-10/A
E
F
09-11
09-12