Lighting Equipment; Replacing Bulbs (Daytona Rs And Sport 1100 I) - MOTO GUZZI V10 CENTAURO Werkstatt-Handbuch

21.4

LIGHTING EQUIPMENT

21.4.1 REPLACING BULBS (DAYTONA RS AND SPORT 1100 I)

Headlight (Fig. 21-06)
To replace the headlamp, remove the front fairing, disconnect the electrical leads from the back, remove the
rubber protective cap and detach the bulb by turning the securing ring nut.
NOTE: When changing the headlight bulb (main/dipped beams) take care not to touch the glass part
of the bulb with the fingers.
The lamp holder, complete with side light bulb, is push-fitted.
Tachymeter, speedometer, rev counter, pilot lights
Remove the front fairing, extract the lamp support and replace the bulbs.
Tail light (Fig. 21-07)
Unscrew the screws «A» securing the reflector, press the bulb firmly in and twist it to remove it from the lamp-
socket.
Indicator lights (Fig. 21-07)
Unscrew the screws «B» that fasten the reflectors to the turn indicators, press the bulbs inwards by rotating them,
and extract them from the lamp-holders.
NOTE: Never tighten too much the screws fastening the reflectors, to avoid breaking them.
21-06
A
B
21-07
167