MOTO GUZZI V10 CENTAURO Werkstatt-Handbuch Seite 130

Clutch shaft disassembly
■ Using the extractor, code 14 92 85 00 «A» - Fig.
14-17 slide out the internal track of the needle
bearings and the shimming nut «C» - Fig. 14-16.
■ Place the complete shaft on a press and, using
extractor No. 12 90 59 00 «B» - Fig. 14-18, compress
the springs so that the two flexible coupling sealing
plate half sections «D» - Fig. 14-16 can be slid out,
then slide out:
– flexible coupling plate «E» - Fig. 14-16;
– springs «F» - Fig.14-16;
– clutch sleeve «G» - Fig. 14-16;
– intermediate gear «H» - Fig. 14-16.
NOTE: The Fig. 14-19 shows the right assembly position of the cup springs «6».
GEARBOX AND COVER
128
B
A
14-17 14-18
E D
F
G
H
14-16
6
14-19
14-20
C