MOTO GUZZI V10 CENTAURO Werkstatt-Handbuch Seite 54

– When reassembling the clutch plate assembly
make sure that the reference marks on a tooth of
the spring pressure plate are lined up with the
reference marks on the flywheel (Fig. 10-42).
– To centre the clutch plates, use the appropriate
tool «A» (part no. 30 90 65 10); tighten the screws
holding the starting ring gear to the flywheel at
1.5÷1.7 kgm torque.
When fitting the starting ring gear to the flywheel,
observe marks «B» shown in Fig. 10-43.
– The piston has an arrow stamped on it that shows
the correct direction for the piston (the arrow must
be pointing forward as shown in Fig. 10-44).
– Cylinder and piston should be matched from the
same selection marked with a letter stamped on each
of them (A with A, B with B, C with C) Fig. 10-45.
52
B
A
10-42
10-43
10-44
10-45