Gearbox Lubrication; Disassembly - MOTO GUZZI V10 CENTAURO Werkstatt-Handbuch

14.1 GEARBOX LUBRICATION (Fig. 14-02)
Checking the oil level
Checking the oil level every 5000 km check that the
oil just reaches the level at plug hole «B».
If the oil is below the level, top up with the
recommended grade and type of oil.
Oil change
The gearbox oil should be changed every 10.000 km
approx. Drain the oil when the gearbox is warm as the
oil is more fluid and drains more easily.
Remember to allow the gearbox to drain fully before
filling with new oil.
«A» Filler plug.
«B» Level plug.
«C» Drain plug.
Quantity required: 0,750 liters of «Agip Rotra MP
SAE 80 W/90» oil.
14.2

DISASSEMBLY

NOTE
The disassembly sequence and operations are
identical for the gear boxes with straight teeth
gear or spiral teeth gears.
In order to disassemble the gearbox into its various
elements, proceed as follows:
lock the gearbox support device «A» - Fig. 14-03,
code 14 92 96 00, in a vice, and position the gearbox
on the support.
In order to easily follow the disassembly operations,
it is advised that the gearbox is positioned in the
neutral position, using device «B» - Fig. 14-03, code
14 92 87 00.
Loosen the locking nut from the layshaft with wrench
«A» - Fig. 14-04, code 12 90 71 00, and «B» - Fig. 14-
04, code 14 90 54 00.
Loosen the odometer control spindle «C» - Fig. 14-
04 and remove the odometer control gear, including
the relative locking sphere, from the layshaft.
124
A
C
A
C
A
B
14-02
B
14-03
B
14-04