Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
A
E
B
A
– Fit tool «A» (part no. 12 91 18 01) to the flywheel
and tool «B» (part no. 30 90 65 10) to compress
clutch springs (Fig. 11-20).
– Unscrew the eight screws «C» holding the ring
C
gear fitted on the engine flywheel (Fig. 11-20).
B
11-20
– Remove ring gear «D» - Fig. 11-21. When refitting
it later on, remember to line up the marks shown by
arrow «E» - Fig. 11-21.
D
11-21
– Take out the clutch plates and the springs from
inside the engine flywheel (Fig. 11-22).
11-22
NOTE: Position the special blocking tool
«A» (code. 12 91 18 01) as shown in Fig. 11-23.
– Unscrew the six screws «B» - Fig. 11-23 that hold
flywheel to crankshaft and remove the flywheel.
These screws must withstand considerable loads
and stresses and cannot be reused. Fit new screws
when reassembling (use Loctite on the screws and
torque up to 4÷4.2 Kgm).
11-23
75
Werbung
Kapitel
Inhaltsverzeichnis
