Checks - MOTO GUZZI V10 CENTAURO Werkstatt-Handbuch

10.2

CHECKS

STRIPPING THE HEADS (Fig. 10-50)
To strip heads proceed as follows:
■ place tool «G» (part no. 10 90 72 00) on the upper valve cap and in the middle of the head of the valve to be
removed;
■ turn in tool screw until it is tight, then tap on tool head (where it touches the upper valve cap) with a mallet so
that the two cotters «A» move apart from upper cap «B»;
■ once the two cotters «A» are apart, tigthen the screw further until you can lift the cottters out of the valve seats;
loosen the tool and take it off the head; then draw out upper cap «B», inner spring «C», outer spring «D», lower
cap «E» and eventually the shims, and valve «F» from inside the head.
G C
E
F
A
B
D
10-50
55