MOTO GUZZI V10 CENTAURO Werkstatt-Handbuch Seite 132

■ check the gear engagement in the 1st to the 5th speeds, then by changing down from the 5th to the 1st, and,
finally, in "neutral". If the engagement operation appears to be difficult, the cover should be disassembled again
and the distance between the gearbox and the cylinder should be shimmed once more; if the engagement
operation appears to be difficult between the 1st and the 2nd speeds, the distance between cylinder and the cover
should be adjusted, as with 2nd an 4th speeds. The shimming washers are supplied in the following dimensions:
0.6 - 0.8 - 1 - 1.2 (Fig. 14-24).
NOTE: The total measurement of control fork shaft «B» - Fig. 14-25 inclusive of lateral shim
adjustments, must be less than 0.2 ÷ 0.3 mm. at the level of lateral housing stops «A» - Fig. 14-25; this
is necessary to permit the control fork shaft to rotate freely.
To measure level «A» - Fig. 14-25, use a depth gauge, adding the distance from the box/cover attachment
surface and the respective internal stops, and taking into consideration the thickness of the gasket.
Special tools, indicated in section 8 "SPECIFIC EQUIPMENT", have been provided for removal/insertion of
shafts, bearings, oil seal rings, etc.
A
130
Fill with Loctite 601
mm 0,6
mm 0,8
mm 1
mm 1,2
B
mm 0,6
mm 0,8
mm 1
mm 1,2
A
14-24
14-25