Side Stand For Motorcycle Support With Safety Switch; Driver Seat Removal (Daytona Rs And Sport 1100 I); Removing The Saddle (V10 Centauro) - MOTO GUZZI V10 CENTAURO Werkstatt-Handbuch

3.18.1 SIDE STAND
SUPPORT WITH SAFETY SWITCH
(VALID FOR ALL MODELS
MANUFACTURED AFTER JAN. 1 1998)
The motorcycle is equipped with a side stand that
supports it during parking («A» - Fig. 03-14).
When the stand is in parking position (all out) the
microswitch («B» - Fig. 03-14) operates a remote
control switch that breaks the current delivery to
the starting motor: in these conditions the motor
cannot be started.
3.19 DRIVER SEAT REMOVAL (DAYTONA RS AND SPORT 1100 I - Fig. 03-15)
To remove the seat from the chassis use a 6 mm Allen wrench to unscrew, from both sides, the screw-pins «A»
which can be reached through the holes «B» made on the tail side.
NOTE: It is not necessary to completely unscrew the screws, just loosen them as required to remove
the seat.
A
3.20 REMOVING THE SADDLE (V10 CENTAURO - Fig. 03-16)
To remove the saddle from the frame, you must: release the saddle using the key «A».
To fasten the saddle, you must fit it into its seat on the fuel tank and then press down on its rear part.
FOR MOTORCYCLE
A
A
B
B
03-14
03-15
03-16
17