Reassembly - MOTO GUZZI V10 CENTAURO Werkstatt-Handbuch

Remove pinion «B» - Fig. 15-13, external bearing «C» - Fig. 15-13, internal spacers «D» - Fig. 15-13, pinion side
bearing «E» - Fig. 15-13 and base spacer «F» - Fig. 15-13 from casing «A» - Fig. 15-13.
In order to remove the external tracks of conical bearings («C» and «E» - Fig. 15-13) from casing «A» - Fig. 15-
14, use the correct extractor «G» - Fig. 15-14, code 17 94 50 60.
C
15.3

REASSEMBLY

Before carrying out reassembly operations, carefully check all the components.
In order to carry out the reassembly operation, follow the disassembly operations in reverse order, paying
attention to the following procedures:
Assemble the crown, checking that the references for the selection of the pinion - crown coupling («A» and «B»
- Fig. 15-15) coincide.
D
134
F
A
D
A
15-16
E
B
15-13
B
Screws «C» - Fig. 15-15 will always have to be
changed; before assembly, carefully degrease the
threads in the drilled pin with trichloroethylene to
ensure good adhesion of the "LOCTITE 601",
previously applied to the threads of the screws
themselves. Secure with a torque of 4 ÷ 4.2 Kgm.
Arrow «D» - Fig. 15-16 on the cover, should be
pointing towards the front.
G
A
15-14
C
15-15