MOTO GUZZI V10 CENTAURO Werkstatt-Handbuch Seite 46

– Release the piston pin circlips, draw out the piston
pin and remove the piston.
If necessary use the suitable tool available on the
market to extract the piston pin.
– Repeat the same procedure on the R.H. cylinder
(Fig. 10-11).
– Loosen the 4 fastening screws and take off the
alternator front cover «A» - Fig. 10-11.
– Put on the fly wheel the special tool to block it «B»
- Fig.10-12 (cod. 12 91 18 01).
– Unscrew the central nut «C» which blocks the rotor
(Fig. 10-13).
– Unscrew the three «D» screws of the generator
stator and remove it (Fig. 10-13).
– Remove washer «E» and extract rotor «F» - Fig.
10-14.
NOTE: to prevent rotor demagnetizing, fit
rotor into the stator.
44
A
B
D
C
E
10-11
10-12
10-13
F
10-14