Clutch - MOTO GUZZI V10 CENTAURO Werkstatt-Handbuch

13

CLUTCH

13-01
Clutch springs (Fig. 13-02)
Check that the springs have not lost their elasticity and are not deformed;
the springs compressed to 20 mm should give a load of 21÷21.5 kg
the springs compressed to 17 mm should give a load of 28.7÷29.7 kg
Spring pressure plate
Check that the plate is not worn in the hole where the command cap operates, and that the surfaces where it rests
on the driven plate are perfectly flat.
Check that the teeth inside the flywheel are in excellent condition.
Driven plates
The thickness of the plate when it is new is 8 mm. The maximum wear thickness is 7.5 mm. Check the state of
the teeth.
Intermediate plate
Check that the surfaces resting against the driven
plates are perfectly smooth and flat and that the
external teeth that engage inside the flywheel are not
worn, otherwise replace.
Starting ring gear
27.970÷28.000
kg 21÷21,5
Check that the surfaces resting on the driven plate
20
kg 28,7÷29,7
are perfectly smooth and flat; check that the teeth that 17
engage the pinion of the starter motor are not worn or
damaged, otherwise replace.
Internal clutch body
Check that the teeth do not show signs of wear from
contact with the plates.
13-02
122