Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 503

®
R&S Scope Rider RTH
TRIGger:SENT:IRFLength <FrameLengthError>
Triggers on frame length errors in transmission sequences, if
set to PPFL. A frame length error occurs, when the total length of the transmission
sequence (including pause pulse) does not match the frame length set with
SENT:PPFLength.
Parameter:
<FrameLengthError> ON | OFF
TRIGger:SENT:PPERioderror <PulsePeriodError>
Triggers on an error in the calibration/sync pulse in transmission sequences of the fast
channel.
Parameter:
<PulsePeriodError>
TRIGger:SENT:PULSeerror <SyncPulseError>
Triggers on a synchronization/calibration pulse error in transmission sequences of the
fast channel.
Parameter:
<SyncPulseError>
TRIGger:SENT:SCRCerror <SlowCRCError>
Triggers on a detected CRC error in serial messages of the slow channel. The CRC
length is 4 bits for short serial messages, and 6 bit of enhanced serial messages.
Parameter:
<SlowCRCError>
15.11.7.3 SENT-Decodierungsergebnisse
Das Framesuffix <m> gibt den Frameindex an, für den das Ergebnis abgefragt wird.
Das Bytesuffix <n> gibt den Byteindex an, für den das Ergebnis abgefragt wird.
BUS:SENT:FCOunt?
BUS:SENT:FRAMe<m>:CSValue?
BUS:SENT:FRAMe<m>:DATA?
BUS:SENT:FRAMe<m>:DSTatus?
BUS:SENT:FRAMe<m>:IDTYpe?
BUS:SENT:FRAMe<m>:IDValue?
Benutzerhandbuch 1326.1578.03 ─ 19
*RST: ON
ON | OFF
*RST: ON
ON | OFF
*RST: ON
ON | OFF
*RST: ON
...................................................................................................... 504
...................................................................................504
....................................................................................... 504
................................................................................... 505
.....................................................................................505
.................................................................................... 505
Fernsteuerbefehle
Protokollanalyse
is
BUS:SENT:PPULse
BUS:
503