Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 399

®
R&S Scope Rider RTH
HARMonic:RESult<m>:LIMViolation?
Queries the result of the limit check for all harmonics. If a single harmonic violates its
defined limit, the limit check for the entire signal fails.
Note: Only if a limit value is defined, a limit check is performed for the harmonic (see
HARMonic:RESult<m>:HARMonics<n>:LIMCheck?
Tip: To query the result of the limit check for an individual harmonic, use
RESult<m>:HARMonics<n>:LIMViolation?
Suffix:
<m>
Rückgabewerte:
<State>
Verwendung:
HARMonic:RESult<m>:NOHarmonics?
Returns the number of harmonics for which results are displayed. The maximum num-
ber of 64 harmonics may be restricted due to the
mand.
Suffix:
<m>
Rückgabewerte:
<NoSelection>
Verwendung:
HARMonic:RESult<m>:NOResults?
Returns the number of results included in averaging or statistics calculations. Invalid
measurements are not included.
Suffix:
<m>
Rückgabewerte:
<NoResults>
Benutzerhandbuch 1326.1578.03 ─ 19
.
1|2 (RTH1002) , 1..4 (RTH1004)
ON | OFF
ON
A limit violation occurred for at least one harmonic - the limit
check for the signal failed.
OFF
No limit violations occurred. The limit check was passed.
*RST: OFF
Nur Abfrage
.
1|2 (RTH1002) , 1..4 (RTH1004)
Bereich: 1 bis 64
Inkrement: 1
*RST: 64
Nur Abfrage
.
1|2 (RTH1002) , 1..4 (RTH1004)
Bereich: 0 bis 4000000000
Inkrement: 1
*RST: 0
Fernsteuerbefehle
Spektrumanalyse
auf Seite 396).
auf Seite 397.
HARMonic:LIMits:TYPE
HARMonic:
com-
399