Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 358

®
R&S Scope Rider RTH
15.4.2.1 Messeinstellungen
MEASurement<m>:ENABle
MEASurement<m>:SOURce
MEASurement<m>:TYPE
MEASurement<m>:AOFF
MEASurement<m>:DELay:SLOPe
MEASurement<m>:ENABle <State>
Enables or disables the measurement.
Suffix:
<m>
Parameter:
<State>
MEASurement<m>:SOURce <Source>, [<Source2>]
Defines the waveform to be measured. For delay, phase, and power measurements, 2
sources are required.
The source can be any active input signal or math waveform. Available source wave-
forms depend on the measurement type, see
Suffix:
<m>
Parameter:
<Source>
<Source2>
MEASurement<m>:TYPE <Type>
Selects the measurement type. For a detailed description, see
pen",
Suffix:
<m>
Parameter:
<Type>
Benutzerhandbuch 1326.1578.03 ─ 19
............................................................................................ 358
........................................................................................... 358
............................................................................................... 358
............................................................................................... 359
.
1..4
ON | OFF
*RST:
.
1..4
C1 | C2 | C3 | C4 | M1 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
C1 | C2 | C3 | C4 | M1 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
auf Seite 89.
.
1..4
PERiod | FREQuency | RTIMe | FTIMe | PPULse | NPULse |
PDCYcle | NDCYcle | DELay | PHASe | MEAN | RMS | CRESt |
STDDev | MINimum | MAXimum | PKPK | BASelevel |
TOPLevel | AMPLitude | AREA | OVRShoot | PREShoot | AC |
DC | ACDC | PPCount | NPCount | RECount | FECount |
PWRP | PWRS | PWRQ | PWRFactor | VPWM | FPWM |
VFPWm
*RST:
...................................................................................359
OFF
Kapitel 4.2.3,
MINimum
Fernsteuerbefehle
Messkurvenanalyse
„Messtypen", auf Seite 89.
Kapitel 4.2.3, „Messty-
358