Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 434

®
R&S Scope Rider RTH
COUNter<m>:SENSe:FUNCtion [<Function>]
Selects the input channel for the counter.
Suffix:
<m>
Parameter:
<Function>
COUNter<m>:SENSe:RANGe <MeterRangeUI>
This command defines the measurement range.
Suffix:
<m>
Parameter:
<MeterRangeUI>
COUNter<m>:SENSe:REFerence:STATe <ReferenceSource>
Selects the reference to be used for the counter.
Suffix:
<m>
Parameter:
<ReferenceSource> INTernal | EXTernal
COUNter<m>:SENSe:REFerence:VALue <RefFreq>
Defines the nominal frequency value to be used as a reference for counter 2.
Suffix:
<m>
Benutzerhandbuch 1326.1578.03 ─ 19
.
1..2
'FREQ 1' | 'FREQ 2' | 'FREQ 3' | 'FREQ 4'
Depends on available channels.
.
1..2
Bereich: 0.1 bis 300
Inkrement: 0.1
*RST: 0.1
.
1..2
EXTernal
The measured value of counter 2 is used as a reference. Specify
the nominal reference frequency for counter 2 using
COUNter<m>:SENSe:REFerence:VALue.
INTernal
An internal reference is used to determine the counter fre-
quency.
*RST: INTernal
.
1..2
Fernsteuerbefehle
Frequenzzähler (R&S RTH-K33)
434